Developer

Robot Arm Simulator

Adjust robot joints in a genuine MuJoCo scene, inspect end-effector coordinates, compare forward kinematics and practise assisted pick/place movement.

View Developer Tools

The robot simulation runs locally in official MuJoCo WebAssembly and does not connect to physical hardware or upload data.

What this tool does

Runs an original primitive four-joint arm in MuJoCo with enforced joint limits, position actuators and collision telemetry.

How to use it

  • Move individual constrained joint sliders or choose the pick preset.
  • Close the labelled assisted gripper near the pick target.
  • Move to the place preset and release while reviewing end-effector telemetry.

Example input and output

Input: Base 0°, shoulder −35°, elbow 70°, wrist −35°

Output: A constrained 3D arm pose, end-effector coordinates and exercise state

Common use cases

  • Learning articulated movement
  • Comparing forward kinematics
  • Practising a simple pick/place sequence

FAQ

Does it control a real robot?

No. It has no hardware or network interface and must not be used to command physical equipment.

Is grasping fully simulated?

Joint motion and contacts use MuJoCo, while grasp attachment is clearly labelled as a kinematic assist rather than a force-closure gripper model.

Does it use a third-party robot model?

No. It uses an original Tool Teaze model built from MuJoCo primitive geometries, avoiding external mesh assets.